A new handbook not only covers the basics and new features of.A. Output forced into this area is cropped off, or possibly the entire page is rescaled to fit or squeezed within the margins.Tabs provide an intuitive environment to preview printer settings, margins and printable extents. Most printer page sizes have a border around the edge that the printer does not print into. When viewing a layout in AutoCAD, the dashed line represents the non-printable margin.
Sheet stays in the printer when the print has been completed. Make sure the paper guides touch the sides of the paper so it will feed properly.Prints do not fall neatly into the basket. Make sure that the guides are firmly in the slots. Adjust both the right and rear paper guides. While pressing the green paper-guide release lever in the back of the paper tray, slide the paper guide to fit the paper size.
Paper from 29 to 43 lbs, labels, and envelopes should be loaded in the MP Tray.E. Paper with a weight of 16 to 28 lbs can be used in the tray. The tray can hold up to 250 sheets of 20 lb paper. The maximum paper mark is located on the right paper guide and marked with 3 red down arrows ▼ ▼ ▼. Make sure that the paper is flat in the tray and below the maximum paper mark. The side to be printed on must be face down.
If the paper is not within the machine's specification, replace it with paper that is within the machine's specification.Use paper that is between 20 lb to 43 lb. Click here for more information. Make sure the paper or media type you are printing on is within specification. - If the top of the page is not cut off or the print is not shifted, then the machine is functioning properly.- If the top of the page is cut off or the print is shifted, go to step 4. Print a test page from the machine: Press → All Settings → Printer → Print Options → Test Print.
- If the top of the page is cut off or the print is shifted, your Brother machine will need service. Print a test page from the machine: Press → All Settings → Printer → Print Options → Test Print. Refer to the section below for Warranty options.5. The MP tray can be used for paper that is 20 lb to 43 lb.If you're printing on glossy paper that is 43 lb or more, print only 1 sheet at a time from the MP tray with back cover open.- If you changed the paper to meet the machine's specification, go to step 5.- If the paper that you're using already meets the machine's specification, and you did not need to change it, your machine will need service.
0 kommentar(er)
